Description

Mk1 Scirocco Fuel Filler Decal

West Coast Rocco’s Fuel Filler Decal is printed on high quality 3M vinyl with a thermal epoxy resin based ink printer. The epoxy thermal ink we use will not fade and is light chemical resistant. They will not scratch or degrade (with normal use) over the life of your vehicle, guaranteed. These recreated decals are measured down to the nearest millimeter. This ensures exact OEM size, fitment and look for your project. OEM colors are swatch match and will represent the original decal. The look and colors are so close you will not be able to tell which one is OEM and which one is not.

Check out the other decals on our site located here: Mk1 & Mk2.

If you have a question about fuel filler decals or need something you don’t see, Email us. Please email us a square photo with measurements. Taking a photo with a tape measure next to the decal is helpful.

Blank: 171201681D / 171 201 681 D
Diesel: 155010024D / 155 010 024 D
Gasoline: 155010024P / 155 010 024 P

Application:

Install wet. Spray both surface and sticky side of the decal with vinyl or window tint application fluid, such as RapidTac. You can also mix up a spray bottle of water and a few drops of baby shampoo or dish soap. You can also use a 15:1 water to alcohol mixture with the soap. The follow is the best recipe for this.

To make 1 Pint you’ll need a spray bottle that can spray a fine mist:

Water – 15 oz / 440mL
(Distilled water is best, but filtered or bottled water works too)
Alcohol – 1 oz of / 30mL
(99%, if using lower percentage, Such as 75% add an additional 25% or .25oz / 7.5mL)
Dish Soap – 1/8 Tsp / 5mL

NOTE: Do not apply vinyl graphics in temperatures below 60º F / 15ºc or over 80ºf / 26ºc. The fluid will not evaporate in the cold and evaporates too quickly in hot conditions. 70ºF / 20ºc room temperature is best for application for surface and air temps.